Well guys I finally nailed down a guy that sold me his axle for 275. My wife is taking delivery tomorrow. SO the build begins!

does anyone have a reamer for chevy HD tierods? ording a kit right now and need to know if I have to buy the 70 dollar reamer?

There is a reamer at Mike's that I aquired back when I was doing mine. I'll check when I'm out there today.

thank you so much, found a steering kit with this stuff

(1) 35" LENGTH OF 1 1/2" O.D. x 1/4" WALL D.O.M. TUBING

(1) 47" LENGTH OF 1 1/2" O.D. x 1/4" WALL D.O.M. TUBING

(2) 7/8-18 LEFT HAND WELD IN THREADED INSERTS

(2) 7/8-18 RIGHT HAND WELD IN THREADED INSERTS

(2) 7/8-18 LEFT HAND JAM NUTS

(2) 7/8-18 RIGHT HAND JAM NUTS

(1) ES2026R DRAG LINK END

(1) ES2027L DRAG LINK END

(1) ES2233L TIE ROD END

(1) ES2234R TIE ROD END

for 215 shipped!

bought the said steering kit above and a few other things for my build.

Stock radius arms 35 bucks for the arms
45 bucks for coil perches and possible caps for above radius arsm

Plans are to cut them down weld up DOM back to heims for the extra long radius arms and custom crossmember.

Anyone have a place where i can buy a welder locally for a good price, I would like to go with the Hobart 187 amp unit and someone to watch my welds..

Tired of buying off the shelf, time to start welding my own rigs.

To find a good deal on a welder, I'd keep up with craigslist and the thrifty nickle. Other than that, any of the welding supply places, and tractor supply will sell you one. Don't know about the good price though.

Make sure you have 220 power available. The Hobarts are good for the price. Order of quality to me would be Miller, Lincoln, Hobart. I put Miller a little higher because you can only buy them at a dealer/welding supply place, I think the Lincoln's sold at Home Depot etc are a little lower quality (but still good units, just hope quality doesn't falter). Hobarts are a good welder. I can give you some pointers and direction. I would also suggest taking the welding classes at Cisco, the AF pays for them

Thanks guys,

I think I am going to buy a stick welder since I want to do thick stuff, may get a tombstone lincoln or a hobart stickmate 235/160 AC/DC

I was just looking at Cisco a couple days ago. wanna get a cert!

We need to talk face to face Stick welder is not what you want... don't feel like typing a novel

x2 on gettign a MIG.
x2 on 220v
take the classes and get comfortable with it. Mig is the only way to go for what we do. Can it be done with a stick welder? Yup. Fast? Nope. Forgiving? Nope.